![]() ![]() Extract and save the image on the device that has the vSphere client installed. zip file containing the Sophos Firewall OVF image. Go to Sophos Firewall free trial and download the. You can deploy an Sophos Firewall OVF image in a VMware environment. Your browser doesn’t support copying the link to the clipboard. ![]() It will remain unchanged in future help versions. Note the IP and port (same IP as was set during the installation process). Reboot the system (make sure to remove the installation disc) and make sure the OS loads correctly: Success!Īt this point, the UTM is ready for configuration.Always use the following when referencing this page. The following screen indicates that the installation has completed without any problems. The entire process should take less than fifteen minutes, depending on the hardware, of course. The disc will be formatted and the installation will begin. In order to actually use Sophos UTM, all capabilities must be installed. ![]() Going this route will leave only a basic installation of Linux on the other end of the install. Manually set the IP for the admin interface.įinally, Sophos has included the option to only use OpenSource software packages. Obviously, avoid using one that will connect to the WAN. I’ve chosen to use the NIC which interfaces with my internal network. Users will then be asked to select a NIC through which to access the WebAdmin interface. Hardware ListĪssuming everything checks out, the next two screens deal with keyboard layout and time zone. ![]() This can save some troubleshooting headaches later on in the set up phase. When the hardware detection is finished, a list of all will be displayed, so check to make sure there are no red flags or missing components. It’s not a bad idea to note the intended purpose for each NIC (ie: external WAN, internal LAN, wireless, etc). I’m not sure exactly what happened, so if anyone that happens to read this encounters the same problem, please feel free to share in the comments. I rebooted, selected ‘Support,’ backed out to the Introduction screen, and then clicked ‘Start’ which resulted in a clean installation. On my first installation attempt, this led to a hiccup in the process where not all of my cards were detected. Selecting ‘Start’ will initiate the automatic hardware detection. Hitting enter will initiate the install and bring up the next screen. (Note: All the screenshots within this post are from a VMware install, not a hardware install, but the process is the same) Sophos UTM 9 Install Assuming the bios is correctly configured to allow for booting from external media, the following screen should appear: Once the appropriate hardware has been acquired and set up and the ISO has been burned to a disc, the installation can begin. Boot up the machine, insert the installation disc, and reboot. They were recognized right away during the install, and I’ve had no issues in the short while that the UTM has been up and running. I also added in three additional gigabit NICs. I’ve replaced the hard drive with a 500 GB Seagate. Should any questions arise, concerned users should reference the Hardware Compatibility List for Sophos UTM v9. My base machine will be a discarded Dell I picked up from a local high school. This process is extremely straightforward assuming the hardware of choice is compatible. Now that we’ve discussed acquiring a Sophos UTM license and downloading the ISO, it’s time for the install. UPDATE: Part 3 – The Setup, Part 4 – Definitions and Rules, and Part 5 – SSL VPN are now available. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |